How much should a mantel overhang?
A mantel should extend a minimum of 3 inches beyond the firebox opening. If the fireplace has facing around the opening, the mantel can also extend 3 or more inches beyond that.
How deep should a mantel be?
6 to 7 inches Depth: A typical mantel depth is 6 to 7 inches. This allows you to place decorative items on the mantel top. A mantel with a smaller depth may lose its presence and be disproportional to the fireplace. The depth of the mantel shouldn't be too deep, however, since heat can become trapped and damage the mantel.
How far should mantle be above fireplace?
about 12 inches As a general rule, the mantel is placed about 12 inches above the fireplace opening. Then adding an inch to the distance for every inch that the mantel protrudes. So a mantel 6 inches deep, would be attached 18 inches above the firebox opening.
How far does a fireplace stick out?
So how far should a fireplace hearth come out? InterNACHI recommends that for fireplaces that have an opening of 6 square feet (0.56 square meters) or smaller, a hearth should extend at least 16 inches (406mm) out into the room from the opening, and by at least 8 inches (203mm) away from the sides.
Should a mantle be the same width as a fireplace?
The answer is a big, resounding yes. As a general rule of thumb, the mantel should at least be three inches wider on both sides of the fireplace. The average mantel width in most homes is six to twelve inches. With these dimensions, you can effectively deflect the heat coming from the firebox.
How wide should my mantle be?
The recommended width for a mantel is 6 inches (15.24cm) wider on both sides. So, if your fireplace is 36 inches (91.44cm), your mantle should be at least 48 inches (121.92cm) wide. Whether you want to install pilasters or not, you'll need to have the same width for your fireplace mantle.
How high should mantle be from floor?
Mantel Height: We recommend installing the mantel 4.5' from the floor. This allows room for stockings during the holidays. Most housing codes and the National Fire Protection Agency (NFPA) state that the bottom of the mantel must be at least 12” away from the top of the fireplace box.
How wide should a mantle be?
The recommended width for a mantel is 6 inches (15.24cm) wider on both sides. So, if your fireplace is 36 inches (91.44cm), your mantle should be at least 48 inches (121.92cm) wide. Whether you want to install pilasters or not, you'll need to have the same width for your fireplace mantle.
How wide should mantle be?
Your mantel should be wider than your fireplace. Typically, a mantel should be a minimum of 3 inches past the firebox on each side. However, more can be better. The average mantel is approximately 6 inches wider than the fireplace on either side, and some can be even wider.
How wide is the average fireplace mantel?
The majority of mantels we sell are from 66”-78”, but we make every mantel custom to your unique space. Mantel Face Height: Is your fireplace in a large or small room? A mantel with a 6” Face Height can stand its ground in a large home, however, it can overpower a smaller space.
How long should floating mantel be?
A safe route is to make it 12” longer than the fireplace box. For instance, if your fireplace box is 42” then you would order a 56” long mantel. The majority of mantels we sell are from 66”-78”, but we make every mantel custom to your unique space.
How close can a wood mantle be to a fireplace?
six inches The National Fire Code dictates that any combustible material (e.g., wood mantel or similar trim) must be at least six inches from the firebox opening. An additional inch of clearance is needed for every 1/8 inch the combustible material or trim protrudes.
What is the code for a mantle in a fireplace?
The National Fire Code dictates that any combustible material (e.g., wood mantel or similar trim) must be at least six inches from the firebox opening. An additional inch of clearance is needed for every 1/8 inch the combustible material or trim protrudes.
Will a wood mantel catch fire?
Combustibles aslo include wood trim, mantels, framing and any other object that can catch fire and burn. Fireplaces must be properly installed with adequate clearances to avoid chemical decomposition caused by heat in a process known as pyrolysis.
How close can a wood mantle be to a wood stove?
(this can be reduced depending on model of stove) Make sure your woodburner is at least 300mm from any combustible materials, such as a wood fireplace surround or mantel. A majority of customers want their woodburner close to the back of the fireplace recess.
How do I protect my wood mantel from heat?
A mantle heat shield can be used to protect mantles from excessive heat and be used to protect TV's and sound bars from heat damage. Mantle heat shield can be used to protect fireplace mantles from excessive heat and damage. They may also be used to shield TV's and sound bars located above a fireplace.
How hot can a wooden mantel get?
Average room temperature is 70-75°F; therefore a 187-192°F surface temperature can be expected. On a solid surface, 150°F is very hot to the touch (to put this in perspective, water boils at 212°F and the average bath water temperature is 110°F).
Can a wood mantle catch fire?
Combustibles aslo include wood trim, mantels, framing and any other object that can catch fire and burn. Fireplaces must be properly installed with adequate clearances to avoid chemical decomposition caused by heat in a process known as pyrolysis.
Can you build a mantle around a wood burning stove?
Decorating around a wood burning stove doesn't have to be complicated or costly. In fact, it's possible to build a DIY fireplace surround if you know the basics. Stone veneer can totally transform the appearance of your fireplace façade by using the traditional, texture-rich building technique of stacking the stones.
Are wooden mantels safe?
Warning: Risk of fire and/or smoke damage may occur as a result of fireplaces and mantels installed without adequate fire-hazard clearances and may lead to asphyxiation, injury and/or death.
Are wood mantels safe?
Building Code & Clearance Information – Fireplaces Designed to Burn Wood. Warning: Risk of fire and/or smoke damage may occur as a result of fireplaces and mantels installed without adequate fire-hazard clearances and may lead to asphyxiation, injury and/or death.
How high should a mantle be above a wood stove?
As a general rule, a mantel is placed about 12 inches above the fireplace opening. Add an inch to the distance for every inch that the mantel protrudes. So, a mantel 6 inches deep would be attached 18 inches above the firebox opening.
Can cement board be used as a heat shield?
Strong, durable and resistant to water damage, DUROCK® Next Gen Cement Board is ideal for use in partitions, walls, floors and ceilings in residential construction and can be used as a heat shield.
What clearance is required around a wood burning stove?
36-inch All stoves require a minimum 36-inch clearance to unprotected combustibles above and on all sides of the stove. A single wall stovepipe must have a clearance to combustible walls and ceilings, measured at right angles to the pipe of at least 18 inches. No clearance is needed to noncombustible walls (i.e., concrete).
Will my mantle catch fire?
Combustibles aslo include wood trim, mantels, framing and any other object that can catch fire and burn. Fireplaces must be properly installed with adequate clearances to avoid chemical decomposition caused by heat in a process known as pyrolysis.
How do you fireproof a wall behind a wood stove?
Faux Panels. A common way to help protect the wall behind a wood stove and create a backdrop for your stove includes using masonry veneer faux panels. Stone or brick is a common material to use behind a wood burning stove. These panels help create more of a focal point for a room.
How far should a wood stove be from the wall?
36 inches 1. Standards for clearances from walls and ceilings that are the basis for many local building codes state that all combustible materials, woodwork, unprotected walls, furniture, firewood, etc., should be no closer than 36 inches to a wood stove.
How close can a wood mantel be to a fireplace?
6 inches Fire codes require that mantels made from combustible materials (such as wood) be mounted at least 6 inches above the fireplace opening. A non-combustible material must also be installed between the mantel and fireplace. If you wish to mount the mantel closer, using non-combustible materials is an absolute must.
How far should furniture be away from a wood stove?
Place your wood stove on a floor pad at least three feet away from walls, furniture, curtains, and other flammable material. Similarly, keep anything that can burn at least three feet away from the stove.
Do I need a heat shield behind a wood stove?
Wood stoves require heat shields both under and behind them to protect your home from heat damage. While many wood stoves include heat shields in their design, some do not. Refer to your wood stove to determine if external heat shields are necessary.