Which action shows responsibility toward the aquatic environment Boat Ed?

Which action shows responsibility toward the aquatic environment Boat Ed?

Which action shows responsibility toward the aquatic environment? Responsible boaters use cleaning products that won't harm lakes or rivers.

What is good for cleaning your boat and does not harm lakes or rivers?

Use alternative cleaning products such as baking soda, vinegar, lemon juice, and borax – and don't forget about the power of “elbow grease”. If you use detergents, use phosphate-free, bio-degradable, and non-toxic cleaners sparingly to minimize the amount discharged into the water.

What should you require from others who operate your vessel?

Check that they meet the minimum age and boater education requirements for operation in your state. Make sure they know basic boating safety and navigation rules. Show them how to use the lanyard with the ECOS and require them to use it.

What is a responsible choice for cleaning your boat?

Promptly mop up any fuel spills. Keep your bilge clean. Use bilge absorbents instead of detergents. Reduce the amount of detergent you use when cleaning your boat. Even biodegradable cleaners may harm aquatic plants and animals.

What should the operator of a stand-on vessel do when encountering a give way vessel quizlet?

Stand-on vessel: The vessel that must maintain its course and speed unless it becomes apparent that the give-way vessel is not taking appropriate action. If you must take action, do not turn toward the give-way vessel or cross in front of it.

What is the best way to clean the hull of your vessel to protect the environment?

To protect the environment, use only plain water or environmentally safe, non-phosphate detergents to remove algae and oil from fiberglass hulls. Clean the hull frequently with a long-handled brush at your home or marina to reduce the need for antifoulant coatings.

How do you clean a lake boat?

Follow the steps as appropriate to the watercraft. In all cases make sure the water used does not drain into a waterbody. Rinse hull and other external areas or equipment with high pressure (2,500 psi) hot water (140 degrees F) for 30 seconds. Flush water cooled motors with water for two minutes.

What is the best way to clean the whole of your vessel to protect the environment?

To protect the environment, use only environmentally safe, non-phosphate detergents to remove oil and algae from fiberglass hulls. Avoid abrasive materials, which can remove the shiny top layer (gel coat). Patch holes immediately with a fiberglass patching compound.

What should the operator of a powerboat do when approaching a very large vessel?

Watch out for other vessels, and be ready to slow down and yield to large vessels. Use radar and a radio if you have them. Make your pleasure craft more visible by operating in a group with other small boats. Stay off the water in fog or high winds.

When operating a boat when should you have your appointed lookouts in place?

When operating a boat, when should you have your appointed lookouts in place?

1. Only when visibility is a concern.
2. Before you start the motor.
3. Before all passengers board the boat.
4. Once you have left the dock.

What should boaters do when operating a vessel on different waterways?

Your primary responsibility is to keep a sharp lookout and avoid a collision.

1. Always be sure other boaters are aware of your presence. …
2. Be considerate of other vessels. …
3. Paddle as close to shore as is safe, and avoid channels used by larger craft. …
4. Operate according to homeland security measures.

What should the operator of a give way vessel do to avoid colliding with a stand-on vessel?

Crossing situation: In a crossing situation, the give-way vessel must act to avoid a collision. This may include altering its course to pass astern of the stand-on vessel or slowing down or both. The stand-on vessel should maintain its course and speed.

What should the operator of a give way vessel do to avoid colliding with a stand-on vessel Wuizlet?

Give-way vessel: The vessel that is required to take early and substantial action to keep well away from other vessels by stopping, slowing down, or changing course. Avoid crossing in front of other vessels. Any change of course and/or speed should be large enough to be readily apparent to another vessel.

How do you clean a boat hull in the water?

3:3810:01How to Clean the Bottom of a Sailboat Underwater! (Tips from the Pros #4 …YouTube

How do you clean a boat in water?

3:3810:01How to Clean the Bottom of a Sailboat Underwater! (Tips from the Pros #4 …YouTube

How does a responsible boater protect the shoreline?

Protect the shoreline from erosion, and preserve aquatic vegetation. Reduce throttle to “no wake” speed when close to a shoreline or in small rivers to help prevent erosion. Don't operate in shallow water where your prop or pump intake can stir up bottom sediments and destroy aquatic plants.

Which of the following actions is required of powerboat a when approaching the starboard side of sailboat B in darkness or reduced visibility?

Give way to your starboard side. Powerboat A: When only red and green lights are visible, you are approaching a sailboat head-on. Give way to your starboard side. Powerboat B: When white, red and green lights are visible, you are approaching a powerboat head-on.

What should you do if you are operating a motorboat that is being overtaken by a sailboat?

What should you do if you are operating a motorboat that is being overtaken by a sailboat? maintain present course and speed because The vessel being overtaken is always the stand-on vessel.

When operating a boat or PWC What factors should you consider when taking action to avoid a collision?

To prevent a collision, boat and PWC operators should:

1. Follow the rules of navigation.
2. Pay attention to navigational aids.
3. Keep a sharp watch and appoint one person to be the “lookout.”
4. Maintain a safe speed, especially in congested traffic and at night.
5. Look in all directions before making any turn.

What should boaters do when operating a vessel on different waterways quizlet?

What should boaters do when operating a vessel on different waterways? Avoid spreading non-native species to another area.

What must you do as a boat operator to avoid collisions and watch for signals that indicate need of assistance?

Collisions can be prevented easily if every vessel operator fulfills three major responsibilities.

• Practice good seamanship. …
• Keep a proper lookout. …
• Maintain a safe speed.

When the operator of a give way vessel is taking action to avoid collision which of the following actions are acceptable?

Crossing situation: In a crossing situation, the give-way vessel must act to avoid a collision. This may include altering its course to pass astern of the stand-on vessel or slowing down or both. The stand-on vessel should maintain its course and speed.

What should the operator of a give a way vessel do to avoid colliding with a stand-on vessel?

Crossing situation: In a crossing situation, the give-way vessel must act to avoid a collision. This may include altering its course to pass astern of the stand-on vessel or slowing down or both. The stand-on vessel should maintain its course and speed.

What should the operator of a giveaway vessel do to avoid colliding with the stand-on vessel quizlet?

Stand-on vessel: The vessel that must maintain its course and speed unless it becomes apparent that the give-way vessel is not taking appropriate action. If you must take action, do not turn toward the give-way vessel or cross in front of it.

How do you maintain a boat hull?

The cardinal rule in keeping your hull clean—and in keeping the entire boat serviceable—is to hose down the entire vessel with fresh water after every trip. Clean freshwater will discourage the accumulation of loose salt, sediment, and other unwanted things on your fiberglass surfaces.

How do you clean a powerboat?

0:543:213 Boat Cleaning Tips & Tricks to Tackle Your Toughest Boat StainsYouTube

What should you do to avoid damaging to shorelines and docks?

To avoid causing damage to a person or property with your pleasure craft's wake, you should reduce your speed when passing:

1. Near a swimming or diving area.
2. Close to docks or the shoreline.
3. Wildlife.
4. Paddlecraft or other small boats.

What should boater do when operating a vessel on different waterways quizlet?

What should boaters do when operating a vessel on different waterways? Avoid spreading non-native species to another area.

What actions should you take if you are approaching another boat at night and see a white light?

What Does a White Light Indicate? If only a white light is visible, you may be approaching another craft from behind. You are the give-way-craft and must take early and substantial action to steer well clear by altering your course and passing at a safe distance on the starboard (right) or port (left) side.

What should you do when operating a power-driven vessel and your vessel is being overtaken by a sailing vessel?

When a power-driven vessel B encounters a sailing vessel A, the sailing vessel is ALWAYS the stand-on vessel (unless a sailing vessel is overtaking). In the case above, power-driven vessel B must take EARLY and SUBSTANTIAL action to keep clear of sailing vessel A.